Description
A full drive snout consumable rebuild parts kit for TVS2650 drive snouts.
Aftermarket EATON drive snout rebuild kit
Includes the following parts:
- Quantity 1 SKF flouro-rubber front seal.
- Quantity 1 SKF front bearing.
- Quantity 1 SKF rear bearing.
- Quantity 1 8 ounce (237ml) bottle of JB Performance Supercharger oil with Tribodyn.
- Quantity 1 Permatex anaerobic gasket maker.
- Quantity 1 Drive Coupler- NOT SHOWN

Gear Case Cover Bolt, Stainless Steel
2.5", 52mm seal flush mount drive, keyway pulley style, M45, MP45, M62, MP62 Bare Casting Finish
Whipple vented pulley stud nut, rotor nut, 12 point ARP, 12mm
Whipple Supercharger Pulley, 8 rib, standard offset, 4 bolt, 3.25"
Kenne Bell Supercharger Oil, 8 ounces
Replacement drive coupler steel pin 1"
Throttlebody gasket for Magnuson and TRD Superchargers on Toyota 3.4L engines
GM 3800 Series 2 (L67) M90 Supercharger Pontiac, Holden, Buick, Oldsmobile
supercharger rotor pack seals- left and right
Timing hub assembly for direct drive
Replacement bypass needle bearing set
Bypass valve assembly, right hand Whipple 1.55"
Rotor seal shaft sleeve 