Description
Output Shaft Installation Tool for centrifugal superchargers using a 17mm ID seal and a 10.3mm to 10.75mm shaft size. Made in Iowa. Made in the USA.
Protects the aftermarket PTFE lip seals from damage during installation of the output shaft. This slides over the impeller side of the output shaft so that it can be slide into the seal without damaging the seal lip as it passes through. Be sure to lubricate with Trans-gel during installation.
Fits XB1A.

JB Performance Powerdyne Volute Case Clamp
Rebuild Kit for Extended or Direct Drive Head Units 100AX, 140AX, 140R, 175AX, 200AX, 200R, 210AX, 245AX, 275AX
Drive snout rebuild kit for M series: M45, M62, M90, M112, M122, TVS
Supercharger Needle Bearing Grease
Pulley bolt 1" long
Front Pulley Seal fits Paxton Novi 1000, Novi 2000
Pulley mounting bolt
454 MPI Whipple Supercharger front support mounting bracket tracing
Powerdyne impeller ship BD10, BD550 Triangle shape
Rotor seal shaft sleeve
Supercharger oil change Syringe
IHI rear drive snout bearing
IHI Verado Supercharger Coolant Port Mounting Bolt, Fits 350, 400HP
Magnuson, Magna Charger MP112 G4 discharge base gasket 